结构毕业设计_结构设计图片
本小组汇集学士、硕士、博士等结构毕业设计。需要的龙友可以进行下载,也可以上传结构毕业设计的相关资料,与建筑人一起分享!
  • 86895成员
  • 4086主题
  • 5737回复
  • 0热度
  • 0周热度
  • 0月热度
  • 0总热度

了解更多

检索到4085条内容

0

oliver1997    发表于2009-3-13    986人浏览  1人跟帖   等级:   来自:结构毕业设计  

[博士]Geotechnical analysis of red mud clay   Geotechnical analysis is usually used to determine the essential properties of a soil whose   behavior is affected under known field-loading condition. The

0

oliver1997    发表于2009-3-13    827人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士]THE FLEXURAL RESPONSE OF BOLTED COMPOSITE PANELS AT ELEVATED TEMPERATURE   Carbon fiberlcyanate ester matrix composite panels with bolted connections to aluminum endplates   were tested in four po

0

oliver1997    发表于2009-3-13    1041人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士] FLEXURAL BEHAVIOUR OF SPUN-CAST CONCRETE-FILLED FIBRE REINFORCED POLYMER TUBES FOR POLE   APPLICATIONS   In this study, the feasibility of utilizing the spin casting technique with struc-tural Fi

0

oliver1997    发表于2009-3-13    1019人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士]FEASIBILITY STUDY OF PARTIALLY RESTRAINED CONNECTIONS   In recent years the idea of using partially restrained connections in building structures has   become more practical and economical. Partia

0

oliver1997    发表于2009-3-13    1404人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士] IMPACT OF AASHTO LRFD BRIDGE DESIGN SPECIFICATIONS ON THE DESIGN OF TYPE C AND AASHTO   TYPE IV GIRDER BRIDGES   This research study is aimed at assisting the Texas Department of Transportation (

0

oliver1997    发表于2009-3-13    674人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士] DYNAMIC BEHAVIOR OF TUBULAR BRACING MEMBERS WITH SINGLE PLATE CONCENTRIC CONNECTIONS   During a severe earthquake, the bracing members of a concentrically braced frame have to undergo large   ine

0

oliver1997    发表于2009-3-13    901人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士] SEISMIC BEHAVIOR OF MICROPILES   Micropiles are grouted and small diameter piles that are traditionally used in foundation retrofit.   Experimental evidence has indicated that micropiles behave w

0

oliver1997    发表于2009-3-13    1244人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士]REINFORCED CONCRETE STRUCTURE DESIGN ASSISTANT TOOL FOR BEGINNERS   The objective of this study was a reinforced concrete design tool for architecture students. The   tool, a computer program with

0

oliver1997    发表于2009-3-13    781人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士]Experimental and Analytical Seismic Evaluation of Concrete Masonry-Infilled Steel Frames   Retrofitted using GFRP Laminates   The study conducted herein focuses on investigating the retrofitting e

0

oliver1997    发表于2009-3-13    1177人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士]EVALUATION OF PUSHOVER ANALYSIS PROCEDURES FOR FRAME STRUCTURES   Pushover analysis involves certain approximations and simplifications that some amount of variation   is always expected to exist

0

oliver1997    发表于2009-3-13    858人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士] STUDY TO IMPROVE THE PREDICTED RESPONSE OF FLOOR SYSTEMS DUE TO WALKING   The scope of this study is divided into three topics. To begin, more accurate methods for   estimating the fundamental na

0

oliver1997    发表于2009-3-13    853人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士]DEVELOPMENT OF THE FULL HEIGHT TRUSS FRAME   The full height truss frame (FHTF) is an exciting new residential framing system in response to the   need for low floor-to-floor steel construction.  

0

oliver1997    发表于2009-3-13    806人浏览  1人跟帖   等级:   来自:结构毕业设计  

[硕士]A FINITE ELEMENT APPROACH TO REINFORCED CONCRETE SLAB DESIGN   The objective of this study was the development of a procedure in GT STRUDL to design   reinforced concrete flat plate systems based

0

longbing2007    发表于2009-3-13    2612人浏览  2人跟帖   等级:   来自:结构毕业设计  

[学士]某商务式公寓高层钢框架毕业设计   本次设计为:[学士]某商务式公寓高层钢框架毕业设计   本工程为11层纯钢框架办公楼,结构平面布置如图1.1所示,横向两跨,跨度为6.9m和7.2m。框架11层,7榀横向框架,柱距7.8m。  ...

0

chen19860211    发表于2009-3-12    3441人浏览  1人跟帖   等级:   来自:结构毕业设计  

[学士]某五金厂厂房结构毕业设计   本次设计为:[学士]某五金厂厂房结构毕业设计   建筑类型:主体三层,现浇钢筋混凝土框架结构   设计资料:本工程建筑面积1765.6㎡,丙类厂房,耐火等级二级,抗震烈度六度,建筑设计年...

0

281022123    发表于2009-3-12    1701人浏览  2人跟帖   等级:   来自:结构毕业设计  

[学士]济南某高级技工学校实习车间毕业设计   本次设计为:[学士]济南某高级技工学校实习车间毕业设计   本工程为技工学校实习车间,三层框架结构。楼面采用压型钢板组合楼板,墙面采用夹心聚苯乙烯保温板。建筑面积4527.24...

0

s_hrlu    发表于2009-3-11    4657人浏览  3人跟帖   等级:   来自:结构毕业设计  

[学士]某加工车间厂房毕业设计   本次设计为:[学士]某加工车间厂房毕业设计   该工程建筑层数为三层,总建筑面积1169.16㎡,建筑高度12.8m。结构形式采用框架结构,楼板及屋面板采用预制空心板,梁柱为现浇钢筋混凝土。耐火...

0

huanghui729    发表于2009-3-11    2141人浏览  1人跟帖   等级:   来自:结构毕业设计  

[学士]某五层框架毕业设计图纸   本次设计为:[学士]某五层框架毕业设计图纸   结构体系:钢筋混凝土框架结构   建筑抗震设防烈度:7度   图纸包括:   结构设计施工总说明、基础平面布置图、基础详图、框架柱平面分布...

0

ludesong    发表于2009-3-11    4131人浏览  2人跟帖   等级:   来自:结构毕业设计  

[学士]多层砖混结构住宅毕业设计   本次设计为:[学士]多层砖混结构住宅毕业设计   本工程为多层砖混民用住宅。建筑层数为六层、建筑高度为20.38m,基底占地面积为574.33㎡、总建筑面积3470.0㎡。抗震设防烈度7度、场地类别...

0

winsk4    发表于2009-3-11    1257人浏览  1人跟帖   等级:   来自:结构毕业设计  

[学士]某框剪综合楼毕业设计计算书   本次设计为:[学士]某框剪综合楼毕业设计计算书   本次设计工程为一综合办公楼,建筑主体结构共有8层,总高27.3m,无地下室, 1层层高3.3m,其余层层高均为3.0m;突出屋面的塔楼为电梯机...

热门标签